Painting instructions for Into Interior Paint

Painting instructions for Into Interior Paint. Into Interior Paint is a plastic-free, fast drying, breathable and odourless water-based paint suited to unpainted or previously painted interior wood, board and stone surfaces, such as walls and ceilings in dry spaces. Into is ideal for plaster board, fibreboard and brick surfaces. Into Interior Paint is an excellent alternative for chalk paint since it is quick to use and easy to re-paint.



Always choose colours in the space and lighting where the paint is intended for. Lighting and gloss level of the paint affect the perception of colour. Stir the paint well before and during painting. Reserve and mix enough paint for large surfaces to avoid potential colour variation in different batches. Paint a test patch on a separate piece of similar material to ensure the colour is correct. Please note that the paint attains its true colour once it has dried properly. Use plenty of paint, as a roller or paint brush can cause uneven texture and gloss levels with too little paint. Take care of the painting environment and protect untreated surfaces with masking tape, paper, cardboard or protective film. If you paint decorative patterns or surfaces that use masking tape, we recommend a longer drying time before taping the painted surface and re-painting.


Painting instructions for Into Interior Paint

Application & Painting conditions

We recommend using paint roller or ordinary paint brush depending on the surface material. The surface to be painted must be dry, the relative air humidity below 80 % and the temperature at least +10°C. The painted surface is touch dry in approx. 30 minutes and ready for a re-coat in 2 hours.

Unpainted surfaces: Clean the surface of dust. Wash dirty surfaces with Uula Washing Agent following the instructions. Allow to dry thoroughly before painting. Level all cracks and holes with filler if necessary, and clean the surface after sanding. Prime new surfaces with Into Primer. Apply two coats of Into Interior Paint, leaving a minimum of 2 hours between coats. Thin with water if necessary.

Old painted surfaces: Remove peeling and flaky old paint. If necessary, use the efficient and safe Uula Paint Remover to remove old paint layers. Roughen glossy or hard surfaces with a sandpaper to ensure adhesion. Wash dirty surfaces with Uula Washing Agent following the instructions. Allow to dry thoroughly before painting. Level all cracks and holes with filler if necessary. Remove sanding dust and clean the surface before painting. Apply two coats of Into Interior Paint, leaving a minimum of 2 hours between coats. Thin with water if necessary.


Additional information

Coverage: Approximately 7m2/litre depending on the roughness and porosity of the surface.
Thinner: Water
Cleaning of equipment: Wash with soap and water straight after finishing painting.
Storage & prevention of environmental impact: Keep in a cool and dry place. DO NOT ALLOW TO FREEZE! Dry and empty containers can be recycled. All liquid waste must be taken to a municipal hazardous waste collection point.


WATCH THE VIDEO FOR INSTRUCTIONS


Be careful with all painted surfaces during the first month. Clean with soft cloths and sponges that do not scratch the surface. Use only neutral washing agents. Rinse the surfaces carefully.

Into Sisustusmaali himmeä on hengittävä, muoviton ja täysin päästötön maali sisäseinien ja kattojen maalaamiseen

iNTO Interior Paint Matt

Read more and order »

Into Sisustusmaali Puolihimmeä on hengittävä, muoviton ja täysin päästötön sisämaali

iNTO Interior Paint Semi-Matt

Read more and order »